SOLAR CABLE H1Z2Z2-K PV1-F
Conductor cross section: 1.5mm²-120 mm² (other specifications can be customized);
Conductor: tinned copper stranded wire, in accordance with EN60228, category 5 soft conductor;
Insulation: Low-smoke and halogen-free irradiation cross-linked polyolefin environmental protection insulation material;
Sheath material: low-smoke halogen-free radiation cross-linked polyolefin environmental protection UV-resistant sheath material;
Insulation color: black (other colors can be customized);
Sheath color: black/red/(other colors can be customized);
Technical indicators:
Cable rated voltage
AC U0/U=1/1kV
DC 1.5/1.5kV
Test voltage: 6500V, 50HZ, 5 minutes;
Temperature class:
-45°C to 125°C;
-45℉ to +257℉;
Ambient temperature:
-40°C to +90°C;
-40℉ to +194℉;
Service life: 25 years (passed TUV/UL);
Maximum short circuit temperature:
280°C, +536°F;
Bending radius:
Fixed installation>4×;
Mobile installation>5×;
Photovoltaic cable is a special cable for solar photovoltaic cables, the models are PV1-F, H1Z2Z2-K.
Due to the particularity of the photovoltaic power generation system, there are special requirements for photovoltaic wires. Photovoltaic wires need to be resistant to weather, high temperature, friction, ultraviolet radiation, ozone, hydrolysis, acid, and salt. Linked polyolefins fit this profile. Polyvinyl chloride (PVC) or cross-linked polyethylene insulation is slightly worse in heat resistance than irradiation cross-linked polyolefin insulation, so ordinary wires cannot be applied to photovoltaic lines.
Standard: EN50618 Construction
Conductors:Tinned copper conductor, class5
Insulation: Halogen-free cross-linked, flame retardant compound
Sheath: Irradiation cross-linked polyolefin insulation
Application: *For free and stationary or for freely suspended outdoor and indoor cabling between the solar modules, or between the module strings and the DC/AC inverter, for example in line with HD 60364-7-712 on PV systems, and EN 50618 on H1Z2Z2-K cable type,etc....; *Short circuit and earth fault protected per EN 50618, Annex A, and per HD 60364-5-52Photovoltaic systems with DC system voltage up to 1800 V to ground.
* As per EN 50618, Annex A, inside electrical installation pipe/ duct/ channel, plaster, and appliance, as well as inside or connected to double insulated/ protected appliance or system of protection class II.
